PLMN 2G SPECIFICATION


To access GSM Mobile Network the unit must be equipped with 2G PLMN board, available with single or dual SIM card.


BANDS

B2 PCS1900 / B3 DCS1800 / B5 GSM850 / B8 EGSM900

AUTOMATIC SELECTION

SIM CARD

SIM e USIM 3V / 1,8V

MICRO SIM - 3FF

OUTPUT POWER

Classe 4 (2 W) GSM850 / EGSM900

Classe 1 (1 W) DCS1800 / PCS1900

DATA

GPRS Classe 12

UPLINK AND DOWNLINK UP TO 85,6 kbps


NETWORK INDICATOR


Network status is reported by yellow led [S], this indicator is kept off when PLMN is operated by controller board.




FRONT COVER REMOVED


SLOW BLINK

64 ms ON / 2000 ms OFF

REGISTERED ON THE NETWORK

BLINK

64 ms ON / 200 ms OFF

COMMUNICATION IN PROGRESS

QUICK BLINK

64 ms ON / 600 ms OFF

NETWORK SEARCHING

ON

VOICE CALL IN PROGRESS


SIM CARD

Install the SIM card before to operate units equipped with PLMN module.

To insert the micro SIM push it with the cut corner oriented inward until it clicks into place. To remove the micro SIM push in to eject it from its slot.

Disable the PIN code of your SIM card before to install it.





Switch off and disconnect all power supplies.


  • Remove the plastic cover A


  • Insert  the SIM card C
    gold contacts facing up


  • Replace the plastic cover
    prima di mettere in funzione l'unità




For DUAL SIM devices, switch off and disconnect all power supplies.


  • Remove the plastic cover A


  • Insert  the SIM card C
    gold contacts facing up


  • Insert the optional SIM card B,
    gold contacts facing down


  • Replace the plastic cover



ANTENNA

An SMA female coaxial jack is available for devices equipped with PLMN module. Below the antenna requirements for 2G option:




SUITABLE FOR GSM (QUAD BAND)


INPUT POWER

> 10 W

IMPEDANCE

50 ohm

GAIN

≥ 1 dBi

VSWR

≤ 2:1

FREQUENCY

824 ÷ 900 MHz

1710 ÷1990 MHz



THE ANTENNA CAN BE MOUNTED DIRECTLY ON THE COAXIAL JACK OR CONNECTED WITH AN RF CABLE WITH MAX LENGTH OF 3m