Each Avior can control up to 8 WiFi plugs.

Avior must be able to reach the plugs in the same network, so they must be connected to the same Router / Access Point.

A single plug could be controlled by more than one Avior device on the local network and to manage sockets from a different network you will need to enable NAT on your router.

The easiest way is to use DLAN and WLAN commands to control resources belonging to another Avior.

There are two different command modes:

  • ON: turn on once and let plug controllable by local button or any other channel. If the plug loses WiFi connection it stays in the current state.

  • SAFE: switches on and confirms every 60 seconds, if the plug loses the connection it will automatically switch off within 5 minutes.