SAFETY INFORMATION

Do not use this unit near medical devices like pacemakers or hearing aids. This unit may interfere with the operation of these devices.

SWITCH OFF THE UNIT WHEN FLYING. SECURE IT SO THAT IT CANNOT BE SWITCHED ON INADVERTENLY.

Do NOT INSTALL THIS UNIT NEAR PETROL STATIONS, FUEL DEPOTS, CHEMICAL PLANTS OR BLASTING OPERATIONS WHEN THE UNIT CAN DISTURB THE OPERATION OF TECHNICAL EQUIPMENT.

INTERFERENCE CAN OCCUR IF THIS UNIT IS USED NEAR TELEVISIONS, RADIOS OR PERSONAL COMPUTERS.

IF THE DEVICE HAS BEEN STORED IN A COLD ENVIRONMENT, CONDENSATION CAN OCCUR. BEFORE STARTING OPERATIONS, THE DEVICE MUST BE ABSOLUTELY DRY.

IN ORDER TO AVOID POSSIBLE DAMAGE, WE RECOMMEND THAT YOU ONLY USE THE SPECIFIED ACCESSORIES. THESE HAVE BEEN TESTED AND SHOWN TO WORK WELL WITH THIS UNIT,


This device complies with Parts 15, 22, 27 and 24 of the FCC Rules. Operation is subject to the following two conditions:

  • this device may not cause harmful interferences, and
  • this device must accept any interference received, including interference that may cause undesired operation


This device should be installed only by qualified personnel.

Carefully read the instruction manual in its entirely and keep it safe for future reference. It is essential to know the information and comply with the instructions given in the manual to ensure the fitting is installed, used and serviced correctly and safely.


This unit is not designed for and intended to be used in portable applications (within 20 cm or 8 inches of human body) and such uses are strictly prohibited.

This unit is not authorized for use as critical component in life-support devices or systems unless a specific written agreement has been given.


If incorrectly installed in a vehicle, the operation of radio devices could interfere with the correct functioning of vehicle electronics. Verification of the protection of vehicle electronics should form a part of the installation.


No complex software or hardware system is perfect.

Bugs are always present in a system of any size.


In order to prevent danger to life or property, it is the responsibility of the system designer to incorporate protective mechanism appropriate to the risk involved.


All units are 100% functionally tested.

Specifications are based on characterisation of tested sample units rather than testing over temperature and voltage each unit.


Contrive disclaims all liability for damage to the fitting or to other property or persons deriving from installation, use and maintenance that have not been carried out in conformity with the instruction manual.