WIFI MOTION SENSOR - CONFIGURATION

Insert your WiFi Motion Sensor into wall socket:

  Flashes red while trying to establish a connection with the WiFi network.


If your device is already registered in the WiFi network proceed directly to the CONFIGURATION


If the device was already registered in another network you will first need to reset to factory default:

  1. Press the ⊕ button for 10 seconds ⇒ Flashes white 10 times.


SEARCH FOR NEW DEVICES


Open the Avior.AWF software, click to search...



When the scan is complete you will be able to see the devices that are not yet registered in any WiFi network:



To identify the device to be configured look at the MAC address that is shown on the product or on its packaging, double click on the corresponding line within the list.


REGISTRATION TO WIFI NETWORK


If your Router / Access Point supports the WPS1 feature:

  2. Locate and press the WPS button on your Router / Access Point.

  3. Press for 2 seconds the ⊕ button on your sensor.

  4. Led is blinking white while pairing.

  5. Led is solid white for a while once connected to WiFi network.


If you prefer to manually configure access to the WiFi network:



Select the SSID name, enter the PASSWORD and CONNECT.



Once the registration to WiFi network has been completed:

  6. Go back to HOME and proceed with configuration.


CONFIGURATION



Click to show devices already connected to WiFi network.



To identify the device to be configured look at the MAC address that is shown on the product or on its packaging, double click on it.



Set the parameters:

  • Name you want to assign to the Motion Sensor.
  • Backoff time period during which it does not make further notifications after the end of the detected motion (default 10 seconds).
  • Night threshold: light level below which it is considered to be night.
  • Day threshold: light level above which it is considered to be day.
  • Select one or more devices that will receive notifications from this sensor, the list contains the WebId of the Aviors that have been detected in the WiFi network but you can add others manually.

 Click CONFIGURE.


 

Add the sensor as a user for the Avior devices that you have previously specified by entering the MAC address as IDENTIFIER.

Refer to ACCESSORY USERS for details.

 

1 WiFi Protected Setup